AUTONET TV

Go With the Flow (MAF Sensor Replacement)

This MAF sensor is an important part of your vehicle.  What it does is calculate the amount of air going into your engine.  As you may know, air is taken into your engine where it's mixed with fuel.  Then the spark plugs fire, the explosive fuel/air mixture detonates, and these sequential explosions provide the power to get your vehicle moving down the road. 

It makes sense that if the MAF sensor isn't sending the engine's computers the correct information about the amount of air entering the engine, the fuel/air mixture won't be right. It will be either too rich (too much gasoline relative to the amount of air) or too lean (not enough gasoline relative to the amount of air).

In this driver's case, the MAF sensor was damaged and needed to be replaced.  Another thing that may cause the MAF to give an incorrect reading is if its wires are dirty or faulty.  So, replacing or cleaning the wires important as well.

Other symptoms that your MAF sensor is bad? If your engine hesitates when you step on the gas, stalls, or your vehicle is jerky when you accelerate. 

A malfunctioning MAF sensor is not just bad for performance.  Driving with your vehicle in that condition can cause more damage to your engine.  When you bring your vehicle in for us to check, a technician will thoroughly examine your engine to make sure all issues are taken care of.

S T Foreign Auto Service
415 E Brighton Ave.
Syracuse, NY 13210
315-478-2161
www.stforeignauto.com

Steering You Right (Power Steering Signs of Problems)

Nearly every modern vehicle on the road today has power steering, a wonderful invention that makes steering take far less effort than it did in the "good old days."  Today, we take our steering for granted: until something goes wrong, that is.

Most power steering these days is rack-and-pinion, the rack being a metal bar between the front wheels with notches in it and the pinion being a gear whose teeth fits into those notches.  Adding power assist makes it easy to turn. That assist comes in the form of hydraulic fluid that is pressurized by a pump powered by the engine, an electric motor that adds a power assist or a system that uses both an electric motor and hydraulic fluid.

Your vehicle usually gives you a heads up that something is going wrong with its steering. Here are a few signs to look for:

• A humming, whirring, rubbing or grinding sound coming from you engine compartment when you turn.
• Signs of hydraulic fluid leaking, such as wet spots under your vehicle.
• The smell of burning oil while you're driving.
• Steering wheel hard to turn or vibrating.

If you notice any of these signs, it's a good idea to have a trained technician check them out.  They may be signs of:

• Power steering pump going bad
• Steering rack or gear seals wearing out, causing them to lose hydraulic fluid
• Broken fluid hose
• Defective power steering cooler
• Loss of pressure in the power steering gearbox
• Worn out steering pump belt
• Failing electric power steering motor

It's important to have these checked out sooner rather than later. You need to be able to steer properly in order to drive safely. Plus, some of these problems can cause more serious—and expensive—damage if they're not fixed.  Power steering is a wonderful feature of your vehicle.  Keep it well maintained and it will steer you right.

S T Foreign Auto Service
415 E Brighton Ave.
Syracuse, NY 13210
315-478-2161
www.stforeignauto.com

Getting New Tires in Syracuse?

There are so many tire choices in the Syracuse area that selecting the right one can be a bit overwhelming for drivers. And even though it's kind of fun to have new tires on your vehicle, they're a significant investment for most Syracuse area folks so you want do it right.

Tip: talk with your friendly and knowledgeable S T Foreign Auto Service tire professional. He'll help you sort through the choices.

Here are some of the issues you'll talk about: One is size – you know, all those numbers on the side of the tire. The right size is . All new vehicles are required to have stability control which, along with other important safety systems, is calibrated to work with specific tire sizes. Your Syracuse tire professional can help stay within manufacturer's specifications or program a different tire size into your vehicle's computer.

And you'll want to discuss how and where you drive to determine the type of tire you need: summer, winter,  all season tires or all-terrain. There are tires for every Syracuse auto owner's needs.

Like we said, tires are a big investment, so you want to get a good value on tires. Now that doesn't always mean the cheapest tire. A top tier tire from S T Foreign Auto Service will last a long time and give Syracuse drivers good performance throughout its life. Tires sold in Syracuse bargain tire shops may not live up to that promise. Again, your friendly and knowledgeable S T Foreign Auto Service tire professional can give you options that offer the best long-term value within your immediate budget.

Last, with a 2-wheel drive vehicle, it's to always replace both tires on an axle. Modern sensors and computer safety systems for vehicle brakes, stability and traction control need both tires to have the same amount of wear to work properly. And always put the new tires on the rear so you don't fishtail in a turn. With all-wheel drive you should replace all four tires at the same time.

Schedule a tire inspection at S T Foreign Auto Service to see how much life is left in your vehicle tires and seek the help of a professional when choosing new shoes for your vehicle.

Give us a call.

S T Foreign Auto Service
415 E Brighton Ave.
Syracuse, NY 13210
315-478-2161
www.stforeignauto.com

The Need for Speed (Wheel Speed Sensor Maintenance)

Today's vehicles have some pretty amazing technology in them, including a computerized braking system we all pretty much take for granted these days.  Antilock brake systems (ABS) have been around for years but they help drivers stop in much shorter distances reliably than ever before.  When you see your ABS warning light come on, it's important to find out what's causing the problem. It's a safety issue.

Often the problem when the ABS light comes on is a faulty wheel speed sensor.  (In some cases the traction control light will also come on, perhaps because of a non-working wheel speed sensor.) Your vehicle uses the speed sensors to measure the rotational speed at each wheel. That sensor sends the speed data to a computer that can then adjust braking power and prevent your wheels from locking up. 

If any of the wheel speed sensors isn't working right, the ABS warning light will go on and the vehicle's computer will turn off the antilock brake system.  You'll still have working brakes, but you will lose the functionality of that computerized system.

When your vehicle warns you the ABS has a non-working sensor, you can have a technician check to see what's going on. It could be one of the sensors is dirty and a cleaning will solve the problem.  But it also could be that one or more sensors needs to be replaced. 

A technician will use computerized diagnostic equipment to determine what and where the problem is, replace any bad parts and then check to make sure the system is fully operational. 

Antilock brakes and traction control are significant technologies that help prevent your vehicle from slipping on less-than-perfect road surfaces, especially useful during wintery weather.  Make sure they're helping you drive the way they designed to.

S T Foreign Auto Service
415 E Brighton Ave.
Syracuse, NY 13210
315-478-2161
www.stforeignauto.com

Why Maintaining Your Windshield Wipers and Washers Matters (Windshield Wiper and Washer Inspection)

What do mud, bird droppings and frost all have in common? When they’re covering your windshield, they can temporarily obscure your view of the road, leaving you driving blind.  And when you can’t see the road clearly ahead of you, it can be really scary. 

That’s one of the reasons it’s important to maintain your windshield cleaning system, which includes your wipers, blades and washers.  They’re three vital components that work together to ensure you’re clearly seeing what’s going on with the road and drivers around you.

Your wipers are doing the physical work on the surface of your windshield’s glass.  The rubber or silicone is what touches the surface of the glass, and after time and exposure to the elements, wiper blades can get brittle, lose their flexibility, rip and tear to the point where they simply can’t clear the glass.  

What holds the wiper blades close to the glass is important, too.  Conventional blades use a metal frame which holds flexible rubber inserts.  Just the inserts can be changed which keeps replacement costs down.

Another type that’s gaining more popularity is called a beam blade.  It doesn’t have a frame but instead has a stiff beam and blade combination.  Beam blades can conform more snugly to the curved glass used in many recent vehicle designs.  Plus they have a sweeping shape which harnesses the pressure of the air that passes over them to apply more pressure during wiping, especially effective at highway speeds. High-tech rubber wiper blades, what …?! Seriously, they are pretty cool.

If you crossed the conventional frame blade with a beam blade, you’d have the hybrid wiper.  It’s constructed like a traditional wiper with a plastic frame that takes advantage of the aerodynamic shape of a beam blade.

Equally important to your windshield is the washer system since wiper blades simply don’t work on dry glass.  The washers use a pump to shoot fluid on your glass to remove debris, dust and other contaminants. 

All these systems need to always be at the ready since we never know what elements we’ll encounter on the road. Regular inspections and maintenance of your wipers and washers can ensure you’ll be able to see far down the road ahead of you for clearer vision and safer traveling.

S T Foreign Auto Service
415 E Brighton Ave.
Syracuse, NY 13210
315-478-2161
www.stforeignauto.com